3. Paper Jam Button
This is lit red when a paper jam occurs. Pressing this button lowers the stacker tray into the paper removal
position.
4. Cover of the Stacker Control Panel
5. Stacker Collecting Indicator
This flashes green when the stacker tray is collecting output paper.
6. Stacker Full Indicator
This is lit red when the stacker tray is full.
7. Error Indicator
This is lit to indicate one or more of the following errors:
• The handcart is not properly set.
• The stacker front cover is open.
• Jammed paper is still inside the high capacity stacker.
Removing paper
• Use the stacker cart for transporting paper from the high capacity stacker. Do not use the stacker
cart for any other purpose.
• Do not attempt to get inside the high capacity stacker.
• The paper press might leave a mark on the top of the paper stack. To prevent this, put several
sheets of unwanted paper or a protective sheet between the paper press and the paper stack.
1. Open the cover of the stacker control panel, and then press the lower tray button.
To stop the lowering stacker tray, press the lower tray button again.
When the stacker tray is fully lowered, the tray moving indicator stops flashing and remains lit.
Using the Ring Binder and the High Capacity Stacker
69
To Next Page
Loading...
