Solution:
1. In [Advanced Settings] for the custom paper you are using, check the present value in
1222: [Paper Transfer Nip Operation Mode]. Is it [Off]?
Yes Proceed to Step 4.
No Go to the next step.
2. Set 1222: [Paper Transfer Nip Operation Mode] to [Off.]
3. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
4. Using a ruler, measure the length of the area with white spots (excluding the margin).
5. In [Advanced Settings] for the custom paper you are using, select 1101: [Image Position],
and then move the image closer to the trailing edge in the following setting according to
the measured length.
<If white spots appear on Side 1>
[With Feed] of [Image Position: Side 1]
<If white spots appear on Side 2>
[With Feed] of [Image Position: Side 2]
6. Print the image. Has the problem been resolved?
Yes Finished!
No Proceed to the solutions in page 105 "Fainter Leading Edge" or page 120 "Worm
Holes: When Using the Clear Toner".
• By increasing the value in [With Feed] of [Image Position: Side 1] or [With Feed] of [Image
Position: Side 2], the image moves to the right (trailing edge). The leading edge margin increases
and the trailing edge margin decreases.
White Spots, Colored Streaks
White spots and colored streaks appear on solid-fill images.
Spots
101
To Next Page
Loading...
