Ricoh PRO C7210

[Side 1], [Side 2]
• [FC/FCS]
[Side 1], [Side 2]
• [FCS]
[Side 1], [Side 2]
• [S]
[Side 1: Clear/Special], [Side 1: White]
[Side 2: Clear/Special], [Side 2: White]
2. Print the image. Has the problem been resolved?
Yes Go to next step.
No Repeat Step 1 to 2.
3. Do white spots appear?
Yes Contact your service representative.
No Finished!
(d) Adjust the paper transfer setting
1. In [Advanced Settings] for the custom paper you are using, select 1214: [Paper Transfer
Output], and then adjust the value in the following corresponding settings.
• [BW]
[Side 1], [Side 2]
• [FC/FCS]
[Side 1], [Side 2]
• [FCS]
[Side 1], [Side 2]
• [S]
[Side 1: Clear/Special], [Side 1: White]
[Side 2: Clear/Special], [Side 2: White]
2. Print the image. Has the problem been resolved?
Yes Finished!
No Contact your service representative.
Uneven Density
135