No Repeat Steps 1 and 2.
3. Is the toner fusibility within the permissible range?
Yes Finished!
No Contact your service representative.
• After performing the solution, it is recommended to perform the color calibration of the external
controller.
• Check the toner fusibility as follows:
• The printed image does not come off.
• The toner does not come off even if it is lightly rubbed by a nail.
• The toner does not come off even if it is rubbed by the cloth for cleaning the contact glass.
Uneven Gloss: Thick Paper
When duplex printing is performed on thick paper, uneven glossiness occurs in the area 204 mm from
the leading edge of paper.
204 mm (8.0 in.)204 mm (8.0 in.)
DFP434
Cause:
This may occur if:
• Printing is done at low temperature
• Paper with a thickness equivalent to Paper Weight 8 or higher is used
• Coated paper with a thickness equivalent to Paper Weight 5 or higher is used
7. Image Quality Problem: Full Page
166
To Next Page
Loading...
