Uneven Gloss: Belt Marks
Glossy belt marks may appear.
80 mm
(3.1 in.)
80 mm
(3.1 in.)
80 mm
(3.1 in.)
DXT849
Cause:
This may occur if:
• Printing is done at low temperature or humidity
• When printing on synthetic papers.
• When printing on very smooth papers.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
Solution:
1. Increase the temperature and humidity of the operational environment.
Temperatures should be above 23 °C, and the humidity should be above 50 %.
2. Print the image. Has the problem been resolved?
Yes Finished!
No Contact your service representative.
Uneven Gloss: Transparency Film
Uneven glossiness occurs when printing on very smooth papers.
Uneven Density
171
To Next Page
Loading...
