Cause:
When printing images with a large area, such as solid fill images, on transparency film, the toner wax
on the fusion belt may roll up onto the surface of the pressure roller, causing stains to appear on the
back of the film.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
Solution:
1. Adjust the paper feed interval. This will decrease the throughput, but is it OK?
Yes Go to the next step.
No Contact your service representative.
2. In [Advanced Settings] for the custom paper you are using, select 1237: [Print Speed
(Sheet Interval Adj)], and then decrease the value in the following corresponding settings
by 20%.
• [BW/FC/FCS]
[BW/FC/FCS]
• [FCS]
[Clear/Special], [White]
3. Print 2 or more sheet. Has the problem been resolved?
Yes Finished!
No Repeat Step 1 to 3.
If the problem persists, contact your service representative.
Toner Scattering: Lines
Parts of a line exhibit scatter.
This may occur in a line that is 5 mm (0.2 inches) or less from the leading edge, or in a line that is 1.5 to
5 mm (0.06 to 0.2 inches) from an image on the side of the image facing the trailing edge.
7. Image Quality Problem: Full Page
176
To Next Page
Loading...
