• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
Solution:
Carry out the following sequence of procedures "(a) Adjusting the image transfer output", "(b) Adjusting
the printing speed", "(c) Changing the paper direction", or "(d) Adjusting the image position".
(a) Adjusting the image transfer output
1. In [Advanced Settings] for the custom paper you are using, select 1212: [Image Transfer
Output], and then check the present value in the following corresponding settings. Is it
lower than 10?
• [BW]
[Black]
• [FC/FCS]
[Black]
Yes Go to the next step.
No No further improvement is likely. Contact your service representative.
2. Select 1212: [Image Transfer Output], and then increase the value in the following
corresponding settings by 1.
• [BW]
[Black]
• [FC/FCS]
[Black]
3. Print the image. Has the problem been resolved?
Yes Finished!
No Repeat Steps 1 to 3. If the problem persists even though you have increased the
value to "10", contact your service representative.
(b) Adjusting the printing speed
1. In [Advanced Settings] for the custom paper you are using, select 1231: [Print Speed],
and then set the value in the following corresponding settings to [Low].
• [BW/FC/FCS]
Dirtied Printouts
181
To Next Page
Loading...
