Ricoh PRO C7210

[Clear/Special], [White]
• [S: Fuser Setting HQ]
[Clear/Special], [White]
8. Print 10 or more sheets. Has the problem been resolved?
Yes Finished!
No Go to the next step.
9. Select 1232: [Fusing Temperature], and then increase the value in the following
corresponding settings by 5°C.
• [BW/FC/FCS]
[Heat Roller Temp]
• [FCS]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [S]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [BW/FC/FCS: Fuser Setting HQ]
[Heat Roller Temp]
• [FCS: Fuser Setting HQ]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [S: Fuser Setting HQ]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
10. Print 10 or more sheets. Has the problem been resolved?
Yes Finished!
No Repeat Steps 9 and 10. If the problem persists even if you lower the value to
200°C, contact your service representative.
• After performing the solution, it is recommended to perform the color calibration of the external
controller.
• Increasing the fusing temperature may have the following side effects:
• Paper curl increases (causing a paper jam).
• Glossy lines appear.
• The image surface becomes grainy.
• Glossy ghosting occurs.
Dirtied Printouts
191