278 mm
(10.9 in.)
R R
DXT870
Cause:
Because of the heat on the fusing unit, the surface profile of the fusing belt may be transferred to the
transparent film, causing white ghosting on the part of the transparent film where images are not printed.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
Solution:
(a) Changing the printing speed
1. Decrease the line speed. This will decrease the throughput, but is it OK?
Yes Go to the next step.
No Proceed to "(d) Decreasing the fusing temperature".
2. In [Advanced Settings] for the custom paper you are using, select 1231: [Print Speed],
and then decrease the value in the following corresponding settings by one level.
If the present value is [High], select [Middle]. If it is [Middle], select [Low].
• [BW/FC/FCS]
[BW/FC/FCS]
• [FCS]
[Clear/Special], [White]
• [S]
[Clear/Special], [White]
Others
199
To Next Page
Loading...
