Solution:
(a) Adjusting [Paper Transfer Output Correction: Paper Edge]
1. In [Advanced Settings] for the custom paper you are using, select 1216: [Paper Transfer
Output Correction: Paper Edge], and then decrease the value in the following
corresponding settings by 1.
• [BW]
[Leading Edge]
• [FC/FCS]
[Leading Edge]
• [S]
[Leading Edge: Clear/Sp], [Leading Edge: White]
2. Print 25 or more sheets. Has the paper jam been cleared?
Yes Go to the next step.
No Repeat Steps 1 and 2.
If the problem persists even though the setting has reached its minimum value,
proceed to "(d) Changing the paper direction".
3. Is the leading edge of the image faded?
Yes Proceed to "(b) Adjusting the leading edge margin", "(c) Adjusting the image
position", or "(d) Adjusting the image position".
No Finished!
(b) Adjusting the leading edge margin
1. In [Advanced Settings] for the custom paper you are using, select 1239: [Margin], and
then increase the value in the following corresponding settings.
• [BW/FC/S]
[Leading Edge]
• [FCS]
[Leading Edge: Clr/Sp], [Leading Edge: White]
2. Print the image. Has the problem been resolved?
Yes Finished!
Messages Reporting Paper Misfeeds
215
To Next Page
Loading...
