5. Select [1 Sided] or [2 Sided] for [Original:].
6. Select [Magazine].
7. Press [OK].
8. Press [Edit / Color].
9. Press [Margin Adj.].
10. Specify left margin on the front side to 5 mm and right margin on the back side to 5 mm.
If (J430/J431/J445/J446/J460/J461) Appears
This indicates a paper misfeed when using the two-tray wide LCT (Vacuum Feed LCIT RT5100).
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
Solution:
The factory- set airflow of the wide LCT may not be strong enough to separate the sheets.
Increase the airflow.
1. If the jam code (J430/J431/J445/J446/J460/J461) appears more than 3 times, in
[Advanced Settings] for the custom paper, select 1301: [Main/2-Tray LCIT: Paper Feed
Mode], and then set [Paper Feed Mode: Fan Level] to [Prevent Non Feed (Stronger
Blow)].
2. Print the image. Has the problem been resolved?
Yes Finished!
No Repeat Step 2. If the jam code appears more than 3 times, set [Paper Feed Mode: Fan
Level] to [Prevent Non Feed (Strongest Blow)].
3. Print the image. Has the problem been resolved?
Yes Finished!
No If a few sheets in the paper tray are misfed when thick paper is fed (e.g., 250 gsm or
greater), attach the tab sheet holder.
4. If the problem persists, contact your service representative.
8. Troubleshooting Paper Delivery Problems
226
To Next Page
Loading...
