The two-tray wide LCT (Vacuum Feed LCIT RT5120) does not have the Pickup Assist function.
<If custom paper is used>
In [Advanced Settings] for the custom paper you are using, set 1312: [Main/3-Tray LCIT/Bypass]
to [Off].
<If custom paper is not used>
In the [Machine: Paper Feed/ Output] group on the [Adjustment Settings for Operators] menu, set
0303: [Pickup Assist Setting] to [Off].
Three-tray wide LCT (LCIT RT5090) is used.
• Is the airflow strong enough?
The factory-set airflow of the wide LCT may not be strong enough to separate the sheets.
Increase the airflow.
<If custom paper is used>
1. In [Advanced Settings] for the custom paper you are using, select 1311: [3-Tray LCIT],
and then set [Fan Setting] to [On]
2. Increase the value in [Fan Level] of 1311: [3-Tray LCIT].
<If custom paper is not used>
1. In the [Machine: Paper Feed/ Output] group on the [Adjustment Settings for Operators]
menu, set 0301: [3-Tray LCIT: Fan Setting] to [On].
2. Increase the value in 0302: [3-Tray LCIT: Fan Volume Setting].
• Is the tab sheet holder attached?
By attaching the tab sheet holder, you can prevent air from leaking at the trailing edge of the paper
and improve separation.
For details about attaching the tab sheet holder, see "Preparation" supplied with the machine.
Two-tray wide LCT (Vacuum Feed LCIT RT5120) is used.
The factory-set airflow of the wide LCT may not be strong enough to separate the sheets.
Increase the airflow.
1. Remove the paper, ruffle it, and reload it.
For details about ruffling the paper, see "Fanning the Paper", Preparation.
2. If the problem persists, load the sheets the other way up.
3. If the problem persists, select 1301: [2-Tray LCIT: Paper Feed Mode] in [Advanced Settings] for the
custom paper you are using, and then set [Paper Feed Mode:Fan Level] to [Prevent Double Feed
(Weaker Blow)].
4. If the problem persists, set [Paper Feed Mode:Fan Level] to [Prevent Double Feed (Weakest Blow)]
Troubleshooting Image Quality Problems
229
To Next Page
Loading...
