Solution:
See, page 324 "Adjusting the Image Position of the Either Side of the Paper".
Image Scaling Error on the Side 2 of Paper
Paper feed direction
Original
Output
Side 1 Side 2
CEZ525
Cause:
An image scaling error on the side 2 of the paper may occur because the paper expands or contracts
after the image on the side 1 of the paper has been fused.
Solution:
See, page 324 "Adjusting the Image Position of the Either Side of the Paper".
Scratches, Streaks, or Vertical Creases Appear on the Image
Cause:
The paper feed speed of the exit motor, switchback entrance, or switchback exit is too high or too low.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
Solution:
<If scratches or streaks appear on the side 2 of the paper>
You can lessen the problem by decreasing the paper feed speed.
Paper Feed Problems Affecting Image Quality
237
To Next Page
Loading...
