Decurling Results in Scratches, Streaks, or Creases
Cause:
The paper feed speed of the decurler unit is too high or too low.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
Solution:
<If scratches or streaks appear on the side 2 of the paper or continuous noise results>
You can lessen the problem by decreasing the paper feed speed of the decurler unit.
1. In [Advanced Settings] for the custom paper you are using, adjust the paper feed speed of the
decurler unit.
• If the degree of decurling is set to "Off", reduce the value in [Decurler: Correction Off] of
1321: [Correct Paper Curl] by 0.5%.
• If the degree of decurling is set to "Weak", reduce the value in [Decurler: Correction
Weak] of 1321: [Correct Paper Curl] by 0.5%.
• If the degree of decurling is set to "Strong", reduce the value in [Decurler: Correction
Strong] of 1321: [Correct Paper Curl] by 0.5%.
2. Print the image. Has the problem been resolved?
Yes Finished!
No Keep decreasing the value by 0.5% until the problem is resolved.
If the problem persists even though the setting has reached its minimum value,
contact your service representative.
<If scratches, streaks, or creases appear on the side 1 of the paper>
You can lessen the problem by increasing the paper feed speed of the decurler unit.
1. In [Advanced Settings] for the custom paper you are using, adjust the paper feed speed of the
decurler unit.
• If the degree of decurling is set to "Off", increase the value in [Decurler: Correction Off]
of 1321: [Correct Paper Curl] by 0.5%.
• If the degree of decurling is set to "Weak", increase the value in [Decurler: Correction
Weak] of 1321: [Correct Paper Curl] by 0.5%.
Paper Feed Problems Affecting Image Quality
239
To Next Page
Loading...
