3. Wipe the guide plates (especially the ridgelines of the bends and the cut-and-bent
portions) with a cloth moistened with alcohol.
4. Close the guide plates and push the buffer pass unit back into the machine.
Cleaning the Rollers and Guide Boards in the Finisher
When a sheet with a high-density image on it is delivered or when the toner is not fused well, toner may
stick to the rollers and guide boards in the finisher, where it may stain the transfer surface or sheet edge.
If you notice such staining, clean the rollers and guide boards in the finisher.
Use the following procedures to clean the rollers and guide boards in the finisher:
8. Troubleshooting Paper Delivery Problems
276
To Next Page
Loading...
