2. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
3. In the [Finishing: Fold] group on the [Adjustment Settings for Operators] menu, set
0710: [Letter Fold-in Position 1: Multi-sheet Fold] to "0.0 mm".
4. In [General Features] in [System Settings], set [Letter Fold-in Position] for multiple
sheets to "7 mm".
5. Print the image. Has the problem been resolved?
Yes Finished!
No Contact your service representative.
<When letter folding is applied to a single sheet>
• This procedure is applied especially to coated paper.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For
details about registering custom papers, see "Specifying a Custom Paper", Preparation.
1. In [General Features] in [System Settings], set [Letter Fold-in Position] for a single
sheet to "7 mm".
2. In the [Finishing: Fold] group on the [Adjustment Settings for Operators] menu,
increase the value in 0709: [Letter Fold-in Position 1: 1 sheet Fold] by "0.2 mm".
3. Print the image. Has the problem been resolved?
Yes Finished!
No Repeat Step 2 to 3. If the problem persists even though the setting value is 4
mm larger than the maximum value, contact your service representative.
Z-Folding is Not Performed Properly
Cause:
If a sheet is curled and its edge touches the guide board, proper folding may not be possible.
This may occur if:
9. Post-Processing Option Troubleshooting
296
To Next Page
Loading...
