2. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
To follow the steps below, attach the decurler unit.
3. In the [Machine: Paper Feed/ Output] group of the [Adjustment Settings for Operators]
menu, set 0304: [Correct Output Paper Curl] to "U Curl Correction Level: Off".
4. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
5. Set 0304: [Correct Output Paper Curl] to "U Curl Correction Level: Small".
6. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
7. Set 0304: [Correct Output Paper Curl] to "U Curl Correction Level: Large".
8. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
9. Set 0304: [Correct Output Paper Curl] to "П Curl Correction Level: Small".
10. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
11. Set 0304: [Correct Output Paper Curl] to "П Curl Correction Level: Large".
12. Print the image. Has the problem been resolved?
Yes Finished!
No Contact your service representative.
High Capacity Stacker
307
To Next Page
Loading...
