[Heat Roller Temp]
• [FCS: Fuser Setting HQ]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [S: Fuser Setting HQ]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
2. Print the image. Has the problem been resolved?
Yes Finished!
No Repeat Steps 1 and 2. If the problem persists even though the value has been
increased to the upper limit, contact your service representative.
• After performing the solution, it is recommended to perform the color calibration of the external
controller.
Glossy Lines at the Edge of the Paper
A glossy line appears in parallel to the paper feed direction. This may occur on solid-fill images.
Cause:
There is a trace (streak) of the paper edge on the fusing belt.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
Streaks
59
To Next Page
Loading...
