[BW/FC/FCS]
• [FCS: Fuser Setting HQ]
[Clear/Special], [White]
• [S: Fuser Setting HQ]
[Clear/Special], [White]
9. Select 1232: [Fusing Temperature], and then set the value in the following corresponding
settings by 10.
• [BW/FC/FCS]
[Corct Temp: Pre-Feed]
• [FCS]
[Corct Temp: Pre-Fd: Clr/Sp], [Corct Temp: Pre-Fd: White]
• [S]
[Corct Temp: Pre-Fd: Clr/Sp], [Corct Temp: Pre-Fd: White]
• [BW/FC/FCS: Fuser Setting HQ]
[Corct Temp: Pre-Feed]
• [FCS: Fuser Setting HQ]
[Corct Temp: Pre-Fd: Clr/Sp], [Corct Temp: Pre-Fd: White]
• [S: Fuser Setting HQ]
[Corct Temp: Pre-Fd: Clr/Sp], [Corct Temp: Pre-Fd: White]
10. Print 20 sheets of the image, then another 10. Does this eliminate the problem?
Yes Finished!
No Go to the next step.
11. Does a paper jam occur by changing the setting?
Yes Change the following settings, and then go to the next step.
• Reset the print speed to [High].
• Reset the value in [Corct Temp: Pre-Feed] of 1232: [Fusing Temperature]
changed in Step 9 to its default value.
No Go to the next step.
12. In [Advanced Settings] for the custom paper you are using, select 1238: [Fusing
Cleaning], and then set the value in the following corresponding settings to [Frequently].
• [BW/FC/FCS]
[Cleaning Interval: BW/FC/FCS]
Spots
89
To Next Page
Loading...
