Ricoh PRO C7210SX - Page 234

1.SC Codes
230
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC751-
36
D
Perfect Binder: Signature exit sensor lag error
When the power was turned on, the cover path was closed and the signature exit
sensor detected paper present, but the LE detect sensor had detected no paper
present.
 Signature exit sensor connector loose, broken, defective
 Sensor defective
 Reconnect the connector.
 Replace the signature exit sensor.
 Replace the LE detect sensor.
 Replace the slave control board.
 Replace the sensor harness.
 Clear the signature jam.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC751-
37
D
Perfect Binder: Entrance path sensor late error
During the automatic exit operation, the entrance path sensor could not detect any
paper within 6860 ms after gluing and stack transport started.
 Entrance path sensor connector loose, broken, defective
 Sensor defective
 Stack transport roller defective
 Reconnect the connector.
 Replace the signature exit roller motor.
 Replace the entrance path sensor.
 Replace the slave control board.
 Replace the motor harness.
 Replace the sensor harness.
 Clear the signature jam.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC751-
38
D
Perfect Binder: Main grip late error
There was no stack received from the sub grip unit; the main grip signature
sensor detected no stack.
 Main grip signature sensor connector loose, broken, defective
 Sensor defective
 Reconnect the connector.
 Replace the signature movement motor.
 Replace the main grip signature sensor.