• [S]
[Trailing Edge Len.: Clr/Sp], [Trailing Edge Len.: White]
3. Select 1216: [Paper Transfer Output Correction: Paper Edge], and then adjust the values
in the following settings in steps of ±1 according to the mode in use.
• [BW]
[Trailing Edge]
• [FC/FCS]
[Trailing Edge]
• [S]
[Trailing Edge: Clear/Sp], [Trailing Edge: White]
4. Has the problem of fainter prints been reduced by increasing or decreasing the value?
Yes Go to the next step.
No Contact your service representative.
5. Has the problem of fainter prints been resolved?
Yes Finished!
No Go to the next step.
6. Select 1216: [Paper Transfer Output Correction: Paper Edge], and then adjust the value in
the following corresponding settings.
If the problem has been reduced by increasing the value by 1, increase the value in steps of 1.
If the problem has been reduced by decreasing the value by 1, decrease the value in steps of 1.
• [BW]
[Trailing Edge]
• [FC/FCS]
[Trailing Edge]
• [S]
[Trailing Edge: Clear/Sp], [Trailing Edge: White]
7. Print the image. Has the problem of fainter prints been reduced?
Yes Go to the next step.
No Contact your service representative.
Unprinted
111
To Next Page
Loading...
