Ricoh PRO C7210X

Solution:
You can lessen the problem by decreasing the paper feed speed of the decurler unit.
1. In [Advanced Settings] for the custom paper you are using, adjust the paper feed speed
of the decurler unit.
• If the degree of decurling is set to "Off", reduce the value in [Decurler: Correction Off] of
1321: [Correct Paper Curl] by 0.5%.
• If the degree of decurling is set to "Weak", reduce the value in [Decurler: Correction Weak] of
1321: [Correct Paper Curl] by 0.5%.
• If the degree of decurling is set to "Strong", reduce the value in [Decurler: Correction Strong]
of 1321: [Correct Paper Curl] by 0.5%.
2. Print the image. Has the problem been resolved?
Yes Finished!
No Keep decreasing the value by 0.5% until the problem is resolved.
If the problem persists even though the setting has reached its minimum value,
contact your service representative.
• Decreasing the paper feed speed of the decurler unit may result in creases, scratches, or paper
jams if thin paper is used.
Stained Paper Edges (4)
14 mm
(0.5 in.)
14 mm
(0.5 in.)
66 mm
(2.6 in.)
CNT013
Cause:
The paper transport rollers or guide plates in the buffer pass unit are stained.
Dirtied Printouts
187