Solution:
1. Perform the following solution within the permissible range:
• Increase the ambient temperature of the machine’s environment.
Increase the temperature to approximately 20°C or higher.
• Set the machine's anti-condensation heater switch to "ON".
• Set the Fusing Unit Off mode, Energy Saver mode, and Sleep mode to "OFF".
2. If the problem persists, contact your service representative.
Stains on the Trailing Edge (20 mm Intervals)
Stains appear on trailing edge of the first 1 to 8 sheets in 20 mm intervals.
Cause:
If fusing is performed too quickly for the transfer, stains may appear at the trailing edge of the paper in
the paper path.
Solution:
1. In the [Machine: Maintenance] group on the [Adjustment Settings for Operators] menu,
execute 0512: [Fuser Unit Speed Adjustment].
2. Print the image. Has the problem been resolved?
Yes Finished!
7. Image Quality Problem: Full Page
184
To Next Page
Loading...
