• [S: Fuser Setting HQ]
[Clear/Special], [White]
3. Print the image. Has the problem been resolved?
Yes Finished!
No Proceed to "(b) If white spots appear on an embossed surface" or "(c) If printing on
an embossed surface is dense".
(b) If white spots appear on an embossed surface
1. In [Advanced Settings] for the custom paper you are using, select 1218: [Paper Transfer
Output: Textured Paper Mode], and then increase the value in the following
corresponding settings by one step.
• [BW]
[Side 1], [Side 2]
• [FC/FCS]
[Side 1], [Side 2]
• [FCS]
[Side 1], [Side 2]
• [S]
[Side 1: Clear/Special], [Side 1: White]
[Side 2: Clear/Special], [Side 2: White]
2. Print the image. Has the problem been resolved?
Yes Go to next step.
No Repeat Step 1 to 2.
3. Is it dense?
Yes Contact your service representative.
No Finished!
(c) If printing on an embossed surface is dense
1. In [Advanced Settings] for the custom paper you are using, select 1218: [Paper Transfer
Output: Textured Paper Mode], and then decrease the value in the following
corresponding settings by one step.
• [BW]
7. Image Quality Problem: Full Page
134
To Next Page
Loading...
