Solution:
1. In [Advanced Settings] for the custom paper you are using, select 1341: [Motor Speed],
check the present value in [Paper Transfer Roller]. Is it -0.5% or lower?
Yes Go to the next step.
No Contact your service representative.
2. Select 1341: [Motor Speed], and then decrease the value in [Paper Transfer Roller] by
0.1%.
3. Print the image. Has the problem been resolved?
Yes Finished!
No Repeat Steps 1 to 3.
Uneven Density: Mixed-color Images
Areas of uneven density occur in images with multiple colors.
Cause:
This issue may occur when printing mixed-color images when temperatures are low, such as on winter
mornings.
Solution:
1. Perform the following solution within the permissible range:
• Raise the temperature.
• Set the machine's anti-condensation heater switch to "ON".
Uneven Density
139
To Next Page
Loading...
