If black is fainter in FC mode, also see the solution in page 124 "Low Image Density of Black Area".
If white spots appear, also see the solution in page 91 "White Spots/Toner Blasting".
(a) Adjust the image density.
1. In the [Machine: Image Quality] group on the [Adjustment Settings for Operators] menu,
select 0201: [Execute Image Quality Adjustment] and execute [Adjust Image Density].
2. Print the image. Has the problem been resolved?
Yes Finished!
No Proceed to "(b) Replacing the parts".
(b) Replacing the parts
1. Check for parts that need replacement.
Yes Replace the necessary parts.
No Proceed to "(c) Adjust the transfer settings".
2. Print the image. Has the problem been resolved?
Yes Finished!
No Proceed to "(c) Adjust the transfer settings".
(c) Adjust the transfer settings
1. What type of paper are you using?
Textured paper Proceed to Step 6.
Low resistance paper Use the paper sealed completely in the plastic bag to prevent it from
absorbing moisture from the air.
If the problem persists, proceed to "(d) Execute developer refreshing".
Others Go to next step.
2. In [Advanced Settings] for the custom paper you are using, select 1214: [Paper Transfer
Output], and then adjust the value in the following corresponding settings by one step.
Adjust the value within ±10 steps from the current value.
• [BW]
[Side 1], [Side 2]
• [FC/FCS]
Uneven Density
141
To Next Page
Loading...
