• [FCS: Fuser Setting HQ]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [S: Fuser Setting HQ]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
2. Select 1232: [Fusing Temperature], and then decrease the value in the following
corresponding settings by 5°C.
• [BW/FC/FCS]
[Heat Roller Temp]
• [FCS]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [S]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [BW/FC/FCS: Fuser Setting HQ]
[Heat Roller Temp]
• [FCS: Fuser Setting HQ]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [S: Fuser Setting HQ]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
3. Print 20 or more A4 sheets.
4. Is the toner fusibility within the permissible range?
Yes Go to the next step.
No Return the value in [Heat Roller Temp] to the value checked in Step 1, and then
proceed to "(b) Decreasing the fusing nip width".
5. Has the problem been resolved?
Yes Finished!
No Return the value in [Heat Roller Temp] to the value checked in Step 1, and then
proceed to "(b) Decreasing the fusing nip width".
(b) Decreasing the fusing nip width
1. In [Advanced Settings] for the custom paper you are using, select 1232: [Fusing
Temperature], and then decrease the value in the following corresponding settings by
10°C.
• [BW/FC/FCS]
7. Image Quality Problem: Full Page
206
To Next Page
Loading...
