No Go to the next step.
5. Are there wrinkles?
Yes Go to the next step.
No Finished!
6. Select 1341: [Motor Speed] and decrease the values in [Cooling Roller After Fusing] and
[Paper Output: Diversion Roller] by 0.1%.
7. Print 10 or more A3 sheets.
8. Are there horizontal folds?
Yes Select 1341: [Motor Speed] and increase the values in [Cooling Roller After
Fusing] and [Paper Output: Diversion Roller] by 0.1%, and then proceed to "(b)
Adjusting the printing speed".
No Go to the next step.
9. Are there wrinkles?
Yes Repeat Steps 6 and 9.
No Finished!
(b) Adjusting the printing speed
1. In [Advanced Settings] for the custom paper you are using, select 1231: [Print Speed],
and then check the present value in the following corresponding settings.
• [BW/FC/FCS]
[BW/FC/FCS]
• [FCS]
[Clear/Special], [White]
• [S]
[Clear/Special], [White]
• [BW/FC/FCS: Fuser Setting HQ]
[BW/FC/FCS]
• [FCS: Fuser Setting HQ]
[Clear/Special], [White]
• [S: Fuser Setting HQ]
[Clear/Special], [White]
Paper Feed Problems Affecting Image Quality
243
To Next Page
Loading...
