• Paper curling
• Not stacked properly
• Paper jams
• Folded edges
Cause:
Curling may occur due to differences in the fusion and pressure application temperatures. Paper output
during post-processing may also fail to occur properly.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
Solution:
If the decurler unit is used
1. In [Advanced Settings] for the custom paper you are using, select 1321: [Correct Paper
Curl], and then set [Correct Mode] to [U Curl Correction Level: Large] or [П Curl
Correction Level: Large] according to the curl.
2. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
3. Is the finisher shift tray selected to the output tray?
Yes Proceed to Step 6.
No Go to the next step.
4. Select the finisher shift tray to the output tray.
5. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
9. Post-Processing Option Troubleshooting
310
To Next Page
Loading...
