First, print the format and measure the length of specified parts. By specifying the measured length on the
machine, you can adjust the image position automatically.
It is necessary to specify the settings for each paper size being used. The adjusted settings are stored as
custom paper presets and can be applied again in the future.
To adjust the image position, the machine administrator privilege is required.
• When manual adjustments or adjustments using a template are performed, even if 1103: [Image
Position Feedback Correction] is set to [Detection Mark: Back] or [Detection Mark: Front & Back],
the adjustments may not correct the image position.
Supported paper size and paper type
Supported Paper Size
A3 , A4 , A4 , B4 , B5 , B5 , DLT , Legal , Letter , Letter , Government LG , 8K ,
16K , 16K , 12 × 18 , 13 × 19.2 , 13 × 19 , 13 × 18 , SRA3 , SRA4 , SRA4
Unsupported Paper Type
Index paper, tracing paper, label paper, envelope, magnet paper, clear file
• There is no limit to paper thickness.
Preparation
To adjust the image position, you need to:
• Prepare a 500 mm or longer stainless steel ruler (with the scale in 0.5 mm) and magnifier (for
measuring the format)
• Check the supported paper size and paper type.
• From the supplied CD, print the file of the format matching the size of the paper requiring image
position adjustment.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
• Select 1101: [Image Position], and then adjust the image position on Side 1. For details about
adjusting the position, see page 324 "Adjusting the Image Position on Side 1".
• Select 1101: [Image Position], and then set the values in the following settings to "0".
[Across Feed] of [Image Position: Side 2]
[With Feed] of [Image Position: Side 2]
[Across Feed] of [Image Position: Adjust Front & Back]
11. Advanced Instructions
332
To Next Page
Loading...
