Cause:
Transfer blur occurs due to speed fluctuation of the intermediate transfer belt.
This may occur if printing using special color only.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
Solutions:
1. In [Advanced Settings] for the custom paper you are using, select 1212: [Image Transfer
Output], and then increase the value in [Clear/Special] and [White] of [S] by one step.
2. Print the image. Has the problem been resolved?
Yes Finished!
No Contact your service representative.
Banding: Short Pitch
When printing an image including solid-fill parts, jitters appear in the area from the solid-fill parts to a
point 95 mm away from the trailing edge of the paper, extending approximately 20 mm at intervals of 3
mm.
Bands
69
To Next Page
Loading...
