(b) If printing an original that has solid-fill images at the trailing edge of a page and half-tone
images at the leading edge of the next page
1. Can you rotate the original by 90 or 180 degrees?
• A: Rotation by 90 degrees
• B: Rotation by 180 degrees
Yes Rotate the original by 90 or 180 degrees.
No Proceed to Step 3.
2. Print the image. Has the problem been resolved?
Yes Finished!
No Go to the next step.
3. In [Advanced Settings] for the custom paper you are using, select 1237: [Print Speed
(Sheet Interval Adj)], and then adjust the value in the following corresponding settings.
Increase the gap between the pages to move the location of the jitters away from the half-tone part.
Increase the value by 1% to move the image toward the leading edge of the paper by
approximately 5 mm.
• [BW/FC/FCS]
[BW/FC/FCS]
• [FCS/S]
[Clear/Special], [White]
4. Print the image. Has the problem been resolved?
Yes Finished!
Bands
73
To Next Page
Loading...
