[Side 2: Clear/Special], [Side 2: White]
2. Print the image. Has the problem been resolved?
Yes Finished!
No Repeat Step 1 to 2.
If the density becomes too low or white spots appear, contact your service
representative.
Jitter: Jitter during Paper Transfer (Perforated Paper)
When printing on perforated paper, such as for business card printing, one or more color bands appear
perpendicular to the paper feed direction.
Cause:
The perforated uneven surface may cause fluctuation in the transfer due to the intermediate transfer belt
vibration produced by the jitter during paper transfer.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
Solutions:
1. Load the paper rotated by 90 degrees.
2. Print the image. Has the problem been resolved?
Adjust the print settings according to the orientation of the loaded paper.
Bands
75
To Next Page
Loading...
