Cause:
Transfer fluctuation has occurred due to the jitter produced when the leading edge of the stiff paper is
fed through the paper transfer roller.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
Solutions:
1. Load the paper with its grain direction perpendicular to the paper feed direction.
2. Print the image. Has the problem been resolved?
Adjust the print settings according to the orientation of the loaded paper.
Yes Finished!
No Go to the next step.
3. In [Advanced Settings] for the custom paper you are using, select 1341: [Motor Speed],
and then check the present value in [Paper Transfer Roller]. Is it lower than 0.5%?
Yes Increase the value in [Paper Transfer Roller] by 0.1%.
No No further improvement is likely. Contact your service representative.
4. Print the image. Has the problem been resolved?
Yes Finished!
No Repeat Steps 3 to 4.
Bands
77
To Next Page
Loading...
