• Duplex printing
• Printing on uncoated (especially rough-textured) paper
• Halftone printing
• Printing after halftone printing
• Printing after printing on many small-size sheets
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Specifying a Custom Paper", Preparation.
Solution:
1. In [Advanced Settings] for the custom paper you are using, select 1232: [Fusing
Temperature], and then increase the value in the following corresponding settings by
5°C.
• [BW/FC/FCS]
[Heat Roller Temp]
• [FCS]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [S]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [BW/FC/FCS: Fuser Setting HQ]
[Heat Roller Temp]
• [FCS: Fuser Setting HQ]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
• [S: Fuser Setting HQ]
[Heat Roller Temp: Clr/Sp], [Heat Roller Temp: White]
2. Print 20 sheets of the image, then another 10. Does this eliminate the problem?
Yes Finished!
No Go to the next step.
3. Increase the heating roller’s temperature by 5°C.
4. Print the image. Has the problem been resolved?
Yes Finished!
Spots
87
To Next Page
Loading...
