Ricoh PRO C7210X

3. Print the image. Has the problem been resolved?
Yes Go to the next step.
No Repeat Steps 1 to 3.
4. Does white spotting or toner blasting occur on Side 2?
Yes Proceed to "(b) If the problem occurs on side 2".
No Finished!
(b) If the problem occurs on side 2
1. Which problem occurs?
Toner Blasting In [Advanced Settings] for the custom paper you are using, select 1214:
[Paper Transfer Output], and then increase the value in the following
corresponding settings by "2".
• [BW]
[Side 2]
• [FC/FCS]
[Side 2]
• [S]
[Side 2: Clear/Special], [Side 2: White]
White Spots In [Advanced Settings] for the custom paper you are using, select 1214:
[Paper Transfer Output], and then decrease the value in the following
corresponding settings by "2".
• [BW]
[Side 2]
• [FC/FCS]
[Side 2]
• [S]
[Side 2: Clear/Special], [Side 2: White]
2. Is the value in 1214: [Paper Transfer Output] the one already configured and printed but
not resolved?
Yes Contact your service representative.
No Go to the next step.
Spots
93