Taurus-C1 Training
71
Slide 71
Decurler Unit
The decurler unit is an option, but it is strongly recommended that you
install it.
This unit fits into the left side of the main machine.
It has no purge tray (the purge tray is built into the main machine).
The decurl unit corrects both convex and concave curling, a common
problem with thin paper and prints with high toner coverage.
The decurl unit has two paper paths.
The lower paper path [1] corrects face curling (concave curling), and the
upper path [2] corrects back curling (convex curling).
The decurl unit is raised and lowered with an operator setting to select the
paper path, depending on which type of correction is needed.
No additional notes
To Next Page
