When using media whose printing surface is rolled up on the inside
3. Release the roll holder's holding lever on the left side of the back of the machine.
4. Move the position of the roll holder to match the roll core size of the set media.
There are two types of inner diameter for the roll core of the roll media: 2 inches and 3 inches.
Move the roll holder to the reference position marked on the machine to match the inner diameter
of the roll core.
5. Lock the roll holder's holding lever.
6. Insert the roll core of the roll media to the roll holder.
Insert the roll core as far as possible so that it does not move.
2. Basic Operations
54
To Next Page
Loading...
