Items Selectable values Description
Pre-Heater On/Off
20–70°C (68–158°F)
Specify the heater settings.
Specify these settings according to
the type and properties of the media
being used.
After decreasing the heater
temperature to secure sufficient
drying time, change the printer
settings as follows:
• Increase the value in "Drying
Time".
• Set "Printing Direction" to
"Unidirectional".
• Select a profile with a higher
resolution (more passes).
Depending on the operating
environment, increasing the heater
temperature may cause the
machine's interior temperature to
exceed the permitted range. Be
careful not to increase the heater
temperature too much.
Print-Heater On/Off
20–70°C (68–158°F)
Post-Heater On/Off
20–95°C (68–203°F)
Cure-Heater On/Off
20-95°C (68–203°F)
Auto Paper Cut On/Off If enabled, the paper is
automatically cut after printing.
60 mm (2.36 in)
80 mm (3.15 in)
100 mm (3.94 in)
Specify the margin when using the
Auto Paper Cut function.
2. Functions for L5130/L5160
22
To Next Page
Loading...
