Overview Details Solution
When using the "Apply the
settings from the most recently
submitted job to the new job"
function, the number of copies
and magnification change
incorrectly.
If you check "Apply the settings
from the most recently submitted
job to the new job" in the [Open]
menu, open a file and display
the [Open] menu again, the
"Image" setting may have
changed as follows.
Copies: 0
Magnification: Disabled
(unchecked)
Width: Blank
Height: Blank
Change the settings manually.
Part of the source image
information may not appear.
When you click the [Printer and
Media] tab "Source Image"
"Format", part of the source
image information may not
appear depending on the
language and source image.
This does not affect the print job.
When sending print jobs to
RIP-Queue, the "Print Info:"
message appears.
When sending print jobs to RIP-
Queue, the "Print Info:" message
appears in "Status" on the [Print]
tab on the Job Editor screen.
This does not affect the print job.
If entering a large number in
the spin box, the application is
terminated forcibly.
If entering a large number that
exceeds 55 digits in the spin
box, the application is
terminated forcibly.
Do not enter a large number
exceeding 55 digits in the spin
box.
The "Status" reports do not
match between RIP-Queue
and Job Editor.
The "Status" report in the Printer
area of RIP-Queue and that on
the [Print] tab of Job Editor do
not match.
The data reported via RIP-Queue
and Job Editor differs.
RIP-Queue reports the printer
status.
Job Editor reports the connection
status with RIP-Queue.
Restrictions on Job Editor
35
To Next Page
Loading...
