20
• Reliable Power source/outlet. Consider using a UPS if your area’s power is unreliable.
• Electronic hygrometer/thermometer (to monitor the relative humidity of the room the printer is operating
in). Keep it near the printer at all times 15°C to 32°C (59°F to 90 °F).
• Humidifier to increase humidity if it falls below 45% humidity. Humidity needs to remain between 45% to
80% RH, non-condensing.
• Place the machine near the power source, providing the clearance areas shown. The clearance shown
is necessary for using and servicing the machine.
• Use at an altitude of 2,500 m or less.
• Heat Press or conveyer dryer for heat curing the ink (THIS NEEDS ITS OWN CIRCUIT)
• Stable, Sturdy, and Level Table for the 140 kg (308 lb.) printer.
• Computer with Windows 8.1 or Windows 10 operating system.
• Graphics software installed in the computer, such as Photoshop, CorelDraw, Photoshop Elements, or
Illustrator.
• High Volume Low Pressure (HVLP) electric sprayer or other type of sprayer for applying pretreatment
for dark garments.
1. Rear: 5 cm (approx. 2.0 inches) or more
2. Right: 60 cm (approx. 23.6 inches) or more
3. Front: 60 cm (approx. 23.6 inches) or more
4. Left: 60 cm (approx. 23.6 inches) or more
(approx. 54.7 inches)
To Next Page
Loading...
