Web Image Monitor
These yield counters are displayed under the "Toner" on the "Status" page as shown above.
• The machine displays "Life End Feed Roller", "Life End Transfer Roller" or "Life End Fuser Unit" when
one of these counters reaches each yield.
Counter Reset
The process below shows how to reset the yield counters.
1. Enter the "Maintenance Mode".
2.
Select "Engine Maintenance", and then press "OK" key.
3. Select "Reset Fusing Unit Life", "Reset Transfer Roller Life" or "Reset Paper Feed Life" and then press
"OK" key.
4. Select "Execute" and then press "OK" key.
5. Exit the "Maintenance Mode".
3. Preventive Maintenance
20
To Next Page
Loading...
