Engine Maintenance
Registration
Horiz. Tray1
Adjusts the horizontal registration for tray 1. If the machine
settings are reset to the factory defaults, this value does not
change.
[-40 to 40 / 0 (Default) / 0.1 mm/step]
Vert. Tray1 Plain
Paper
Adjusts the vertical registration of plain paper for tray1. If the
machine settings are reset to the factory defaults, this value
does not change.
[-40 to 40 / 0 (Default) / 0.1 mm/step]
Vert. Tray1 Thick
Paper
Adjusts the vertical registration of thick paper for tray 1. If the
machine settings are reset to the factory defaults, this value
does not change.
[-40 to 40 / 0 (Default) / 0.1 mm/step]
Registration
Vert. Tray1 Thin
Paper
Adjusts the vertical registration of thin paper for tray 1. If the
machine settings are reset to the factory defaults, this value
does not change.
[-40 to 40 / 0 (Default) / 0.1 mm/step]
Horiz. Tray2
Adjusts the horizontal registration for tray 1. If the machine
settings are reset to the factory defaults, this value does not
change.
[-40 to 40 / 0 (Default) / 0.1 mm/step]
Vert. Tray2 Plain
Paper
Adjusts the vertical registration of plain paper for tray 2. If the
machine settings are reset to the factory defaults, this value
does not change.
[-40 to 40 / 0 (Default) / 0.1 mm/step]
Vert. Tray2 Thin
Paper
Adjusts the vertical registration of thin paper for tray 2. If the
machine settings are reset to the factory defaults, this value
does not change.
[-40 to 40 / 0 (Default) / 0.1 mm/step]
Vert. Tray2 Thick
Paper
Adjusts the vertical registration of thick paper for tray 2. If the
machine settings are reset to the factory defaults, this value
does not change.
[-40 to 40 / 0 (Default) / 0.1 mm/step]
Service Program Mode
89
To Next Page
Loading...
Need help?
General
