9
9. Tap the printer in the list.
10. Enter the password for Soft AP, and click [Join].
• You can nd the password for Soft AP in [Passphrase] under
[Soft AP] on the System Settings sheet.
11. Tap the
icon on the smart device.
The application is launched, and available RICOH printers are
automatically searched for.
• An error message appears when Wi-Fi connection failed or
RICOH printers are not found.
Printers are searched for again if clicking [OK].
Click [Cancel] to cancel the search and set up the Wi-Fi set-
tings.
12. Tap [Settings].
13. Tap [Wi-Fi].
14. If the Wi-Fi setting is disabled, toggle the [WLAN]
switch to enable the Wi-Fi function.
Available access points are searched for, and found access
points are displayed in the list.
15. Tap an access point to use.
• Click [Manual Wi-Fi] to specify an access point by manually
specifying SSID, encryption method, and password. After
specifying an access point manually, click [Connect] to estab-
lish a connection.
16. Enter the password to connect with the selected
access point, and tap [OK].
• If the “KeyID” setting is displayed, select the option corre-
sponding to the SSID and entered password.
• If the setting is modied, the authentication password entry
screen appears after [OK] is tapped.
Enter the administrator password (default password is
“888888”. The password can be set from [Modify Password]
in the [Settings] menu.), and tap [OK].
Restart the printer to apply the modied setting to the printer.
• If the smart device is connected with the printer via a Wi-Fi
router, the connection is terminated after the access point
change is applied to the printer. Connect the smart device to
the same access point to connect with the printer via the Wi-Fi
router.
If the connection is established, you can use the printer via the
Wi-Fi router.
5. Connecting with a Smart Device Directly
The printer supports the Soft AP function that enables the printer to
act as an access point (virtual router).
You can directly connect your smart device (smartphone, iPhone,
tablet, etc.) with the printer (without using a Wi-Fi router) using the
Soft AP function.
Install the “RICOH Printer” application to your smart device rst to
use the printer.
• Some of the illustrations or descriptions in this manual may vary
due to changes for improvement in this application, or smart
devices.
For Android or iOS
Enabling the Soft AP function using
the Power Key on the Printer
1. Download the application from the RICOH official
website at:
http://www.ricoh.com/printers/sp150/support/
gateway/
2. Press and hold the power key to turn on the
printer.
3. Press and hold the
power key for 1 second or
longer.
The power indicator turns blue and the Wi-Fi function is ena-
bled on the printer.
To Next Page
Loading...
