How to fix Ricoh All in One Printer that does not turn on?
If your Ricoh All in One Printer is not turning on, ensure the power cord is properly connected. Make sure the power plug is firmly inserted into the wall outlet. Also, verify the wall outlet is not defective by testing it with another working device.
Why do dirty spots appear on copies from my Ricoh All in One Printer?
If dirty spots appear, or an image from the reverse side shows through a copy received by the recipient from your Ricoh All in One Printer, the image density is likely too high. Adjust the image density.
Why does my Ricoh SP 203 SF All in One Printer have frequent paper jams?
To resolve frequent paper jams in your Ricoh All in One Printer, try the following: * Ensure there are no gaps between the paper and paper guides by adjusting the guides. * Avoid printing on both sides of the paper when printing images with large solid color areas, as this consumes a lot of toner. * Use supported paper types. * Do not load paper beyond the upper limit markings on the paper guide.
Why do copies from my Ricoh All in One Printer differ from the originals?
If copied pages do not look the same as the originals on your Ricoh All in One Printer, select the correct scan mode according to the type of original.
Why is the paper blank after photocopying with my Ricoh All in One Printer?
If the photocopied paper is blank when using your Ricoh All in One Printer, ensure that the original was placed correctly.
How to fix print quality issues with certain applications on Ricoh SP 203 SF?
If you cannot print properly when using a certain application or cannot print image data properly, or if some characters are printed faintly or not printed on your Ricoh All in One Printer, change the print quality settings.
Why is there a delay in printing with my Ricoh SP 203 SF All in One Printer?
If there is a considerable delay between the print start command and actual printing on your Ricoh All in One Printer, note that processing time depends on data volume; high volume data, such as graphics-heavy documents, take longer to process, so wait for a while. To speed up printing, reduce the printing resolution using the printer driver.
What to do if paper does not feed smoothly in Ricoh SP 203 SF?
If the paper does not feed smoothly in your Ricoh All in One Printer, use supported types of paper. Load paper correctly, ensuring the paper guides are properly adjusted. If the paper is curled, straighten it. Take out the paper from the tray, fan it well, reverse the top and bottom of the paper, and then put it back in the tray.
Why does paper get wrinkles in my Ricoh SP 203 SF All in One Printer?
If the paper gets wrinkles when using your Ricoh All in One Printer, ensure that the paper is not damp and has been stored properly. Also, ensure the paper is not too thin. If there are gaps between the paper and the paper guides, adjust the paper guides to remove the gaps.
How to fix images printing diagonally on my Ricoh All in One Printer?
To address images printing diagonally on pages from your Ricoh All in One Printer, adjust the paper guides to eliminate any gaps between the paper and the guides.
General| Print Technology | Laser |
|---|---|
| Functionality | Print, Copy, Scan, Fax |
| Print Speed (Black) | 22 ppm |
| Print Resolution | 1200 x 1200 dpi |
| Paper Capacity | 250 sheets |
| Display | LCD |
| Duplex Printing | Manual |
| Copy Speed | 22 cpm |
| Copy Resolution | 600 x 600 dpi |
| Scan Resolution | 600 x 600 dpi |
| Fax Speed | 33.6 Kbps |
| First Print Out Time | 10 seconds |
| Fax Transmission Speed | 3 seconds per page |
| Connectivity | Ethernet |
To Next Page
