• When printing on a sheet of Letter or Half Letter paper
Position the card so that it is centered at the intersection.(The same position applies to both the
front and back of the ID card.)
3. Press the [Start] key.
A message prompting you to place the original back side down on the exposure glass appears on
the display.
4. Within 30 seconds, place the original back side down and top to the machine rear on the
exposure glass, and then press the [Start] key again.
• For the ID card copy function, you can set the machine to print a line in the middle of the printed
paper. Specify [ID Card Center Line] under Copier Features.
•
You can press the [Escape] key to exit to the previous level of the menu tree.
• Regardless of the machine's reduction or enlargement ratio setting, an ID card copy will always be
made at 100%.
• You can change the machine's default [Reduce/Enlarge] setting to always make photocopies in ID
card copy mode. In addition, if the [Shortcut to Func.] key is not set to [ID Card Copy Mode], you
must configure the machine's default setting to perform ID card copy. For [Reduce/Enlarge], see
page 134 "Copier Features Settings".
4. Copying Originals
76
To Next Page
Loading...
