6. Enter the access code, and then click [OK].
The default access code is "Admin".
7. On the [Wireless] tab, select [Manual Setup] for [Configuration Method].
8. Select the authentication method in [Authentication]. Configurations differ according
to the authentication method.
• WPA2-PSK or Mix Mode WPA/WPA2
• Enter the SSID of the router (access point) in [SSID].
• Enter the WPA passphrase of the access point (router) in [WPA Passphrase].
• Open System or Shared Key
• Enter the SSID of the router (access point) in [SSID].
• Select [WEP] in [Encryption].
Do not select [None] except in special circumstances. If you select [None], the
security system may not work.
• Select [64 bit] or [128 bit] in [WEP Key Length].
• When you register multiple encryption keys, select a registration number between
[ 1] and [ 4] in [WEP Transmit Key ID].
• Select [Hexadecimal] or [ASCII] in [WEP Key Format].
• Enter the WEP key in [WEP Key].
9. Click [Apply], and then click [OK].
10. When "Connected" is displayed in [Wireless Status] on the [Wireless] tab, the
connection has been established.
11. Click [OK].
7. Configuring Network Settings Using OS X
110
To Next Page
Loading...
Need help?
General
