[Auto E-mail Notification] tab
The settings on this tab are for sending a notification e-mail when the machine’s status changes.
You can specify up to two recipients.
• [Display Name]
Enter a sender name for notification e-mail.
• [E-mail Address]
Enter the address of the recipient of the alert email.
• [Paper Misfeed]/[Out of Paper]/[Replace Print Cartridge Soon]/[Call Service]/[Replace
Print Cartridge]/[Cover Open]
Select which items to send notifications about.
[SNMP] tab
• [SNMP]
Select whether to enable the machine to use SNMP services.
• [Trap]
You can specify [Target Trap], [SNMP Management Host 1], and [SNMP Management Host
2].
• [Community]
You can specify [Get Community] and [Trap Community].
• [System]
Enter [Location] and [Contact] that are displayed on the top page.
[SMTP] tab
You can specify [Primary SMTP Server], [Port No.], [Authentication Method], [User Name],
[Password], [Device E-mail Address], and [Server Timeout (seconds)].
[POP3] tab
You can specify [POP3 Server], [User Account], [User Password], and [Authentication].
[Wireless] tab (only SP 325DNw)
• [Wireless LAN Status]
The status of the following items is displayed:
[Wireless LAN Status], [MAC Address], [Communication Mode], [SSID], [Wireless Signal
Status], and [Wireless].
• [Wireless LAN Settings]
• [SSID]
Enter the SSID name. Can contain 32 characters.
When you click [Scan List], a list of access points that is currently available
is displayed. You can select the SSID name from the list.
Using Web Image Monitor
57
To Next Page
Loading...
Need help?
General
