Message Cause Solution
"Duplex mode is in off
position for (tray name)"
The duplex mode for the indicated
tray is not available.
You can use one-sided printing
only. Press [Change] to change
the tray's settings, press [JobReset]
to reset the job, or press [Form
Feed] to force printing.
"Ethernet Board Error" An error on the Ethernet is
detected.
Turn the printer off, and then turn it
on again. If the problem persists,
contact your sales or service
representative.
"Exceeded max. No. of
files."
While printing a Sample Print,
Locked Print, Hold Print, or Stored
Print file, the maximum file
capacity was exceeded.
Delete unneeded files stored in
the printer.
"Exceeded max. No. of
pages."
While printing a Sample Print,
Locked Print, Hold Print, or Stored
Print file, the maximum page
capacity was exceeded.
• Delete unneeded files stored
in the printer.
• Reduce the number of pages
to print.
"Exceeded max. print size.
Press [FormFeed] or
[JobReset]."
The specified paper size exceeds
the maximum size supported by
this printer.
Press [Form Feed] to force printing
or [JobReset] to cancel printing.
"Exceeded max. print size.
Press [JobReset]."
The specified paper size exceeds
the maximum size supported by
this printer.
Press [JobReset] to cancel printing.
"Failed to connect to server
for Remote Diagnostics."
The printer cannot communicate
with Remote Communication
Gate.
Check the connection to the
Remote Server Gate.
"Independent-supply toner" Independent-supply toner is set. Use the toner recommended for
this printer.
"IPv6 Address already exists
Link-local
Address(109/209)"
The same IPv6 address is already
used.
Contact your network
administrator.
"IPv6 Address already exists
Stateless
Address(109/209)"
The same IPv6 address is already
used.
Contact your network
administrator.
When Messages Are Displayed
79
To Next Page
Loading...
Need help?
General
Weight and Dimensions
