Message Cause Solution
"IPv6 Address already exists
Manual Config.
Address(109/209)"
The same IPv6 address is already
used.
Contact your network
administrator.
"Load paper in (tray name)" There is no paper in the specified
tray.
Load the specified paper in the
tray, press [JobReset] to reset the
job.
"No privileges to use funct." The logged in user does not have
the privileges to register programs
or change the paper tray settings.
For details about how to set
permissions, see "Configuring
Administrator Authentication",
Security Guide.
"Par. I/F board has a
problem."
The printer's self-diagnostic test
failed due to a loopback error.
Replace the IEEE 1284 board that
caused the error.
"Printer Font Error." There are problems with the
printer's font file.
Turn the printer off, and then turn it
on again.
If the problem persists, contact
your sales or service
representative.
"Problem with Hard Disk
Please call service."
The printer cannot detect the hard
disk.
Check that the hard disk installed
correctly. If the problem persists,
contact your sales or service
representative.
"Problem:Wireless card
Please call service."
The printer cannot detect a
wireless LAN interface board.
Check that the wireless LAN
interface board installed correctly.
If the problem persists, contact
your sales or service
representative.
"Replacmnt Requrd Maint.
Kit"
You need to replace the
maintenance kit.
Contact your sales or service
representative.
"Replcmnt Requrd Drum
Unit"
You need to replace the drum
unit.
Contact your sales or service
representative.
"Repl Requrd Soon Maint.
Kit"
You will need to replace the
maintenance kit soon.
Contact your sales or service
representative to obtain a new
unit.
3. Troubleshooting
80
To Next Page
Loading...
Need help?
General
Weight and Dimensions
